Panasonic WJ-SX650 manual Power-on/off, Operation Start Login, Operation End Logout

■Power-on/off

1.To power on the unit, press the power switch behind the front panel.

2.Power on system controllers and recorders. (Refer to the operating instructions of each system device for how to power on.)

3.When finishing operations, power off each device in the same procedure as power on.

■Operation Start (Login)

By logging into the system as a registered operator, you can control system devices with the authority of that opera- tor.

1.Turn on the power. (Refer to Power-on/off.)

2.Wait until the login standby display appears.

<WV-CU950/650><WV-CU360C/360CJ>

Note: If the password is wrong or no operation has been performed for 5 seconds or more, the LCD display will return to the login standby display.

3.Enter the user ID by pressing numeric buttons, and press the CAM (SET) button.

4.Enter the password by pressing numeric buttons, and press the CAM (SET) button.

<WV-CU950/650><WV-CU360C/360CJ>

Ｍｏｎ-- Ｃａｍ---

The system controller will enter the login status, and the LCD display will become the default status.

■Operation End (Logout)

You need to log out of the system:

•When finishing operations and powering off

•When changing an operator

●WV-CU950/650

During the login status, press the LOGOUT button while holding down the SHIFT button.

The LCD returns to the login standby display.

●WV-CU360C/CJ

During the login status, press the LOG OUT button while holding down the SHIFT button.

The LCD returns to the login standby display.

■Operation Start/End (Auto Login/Logout)

•To activate auto login or auto logout, the setting is required in advance.

•The auto login and auto logout settings is performed in "Controller" – "Auto Login/Logout" of WJ-SX650 Series Administrator Console.

•Auto login and auto logout are set for each DATA port. Operators logging into the system from the same DATA port have the common setting.

•When both auto login and auto logout are set for a DATA port, system controllers connected to the port perform login and logout automatically. Then, the sys- tem controller returns to the status before monitor selec- tion.

56