Panasonic WJ-SX650 manual Setup Procedure, Recorder 1 to 10 on Recorder 11 to 16 OFF, Setup Menu

SETUP PROCEDURE

Before operation, setup of this unit is required. Setup is per- formed from WJ-SX650 Series Administrator Console installed on a PC. (Some settings are available from SETUP MENU of this unit.) The following is an example of setup procedure.

Notes:

•Setup may differ depending on system composition. (Settings of Step 1 and 4 in the following procedure must be performed.)

•For Step 2, 3, 5 and 6 in the following setup procedure, the factory default can be maintained.

Example: camera x 150, recorder x 10, monitor x 32, and system controller x 2 (Terminal mode)

1.Perform the recorder settings.

Recorder Out: Input Board No.5 (When video input sig- nals are supplied from recorders to CAM160 to 151)

Recorder 1 to 10: ON

Recorder 11 to 16: OFF

Note: Check if recorders are properly connected to the DATA port and CAM (camera input channels) currently displayed.

<WJ-SX650 Series Administrator Console> "System" – "Recorder"

<SETUP MENU> RECORDER (Refer to p. 87.)

2.Perform the DATA port settings. (In this example, main- tain the factory default.)

DATA 1, 2, 5 and 6 ports: TMNL

DATA 3, 4, 7 and 8 ports: HDR

Note: Change these parameters when using PS·Data system controllers, etc.

<WJ-SX650 Series Administrator Console>

"System" – "DATA Port"

<SETUP MENU>

DATA PORT (Refer to p. 90.)

<WJ-SX650 Series Administrator Console>

"System" – "VD2/DATA/Cable Comp."

<SETUP MENU>

VD2/DATA/CABLE COMPENSATION (Refer to p. 91.)

3.Perform the LCN (Logical Camera Number) settings. CAM001 to 160: If you change LCN settings, select

desired parameters.

CAM161 to 256: Delete the LCN parameters.

Notes:

•Set LCN parameters for CAM151 to 160 surely, even though these channels accept video input signals from recorders. Without LCN settings, recorder selection is unavailable.

•By deleting the LCN parameters of unused camera channels, operators can select only existing camera numbers.

<WJ-SX650 Series Administrator Console> "System" – "Logical Camera Number"

<SETUP MENU> Not available

4.Perform the camera settings.

CAM001 to 150: Select desired parameters for these cameras. (To use cameras of other manufacturers, set DATA to OFF.) For Cable (cable compensation), select the parameter suited to the cable length.

CAM151 to 160: Set DATA to OFF. (Video input signals are supplied from recorders to these channels.)

38