Paradyne 3160-A2-GB21-50 manual Starting Front Panel Emulation

ACCULINK 316x DSU/CSU

6.Type the letter of the destination drive, followed by a colon (default is C:), then the appropriate directory name (default is C:\FRONTPAN).

If the selected directory already exists, the following message appears: The specified directory already exists. Do you want to overwrite the directory?

If the selected directory is new, the following message appears: The specified directory does not exist. Do you want to create the directory?

7.Select Yes. A confirmation screen appears. Select Install to continue the installation.

8.A Setup Completed screen appears. Select Continue. The Program Manager screen appears with the Front Panel icon.

Starting Front Panel

Emulation

If the DSU/CSU selected is not locally attached to the PC, you must first dial to the remote DSU/CSU before starting front panel emulation. The modem attached to the PC must support AT commands for the Front Panel Emulation software to successfully place the call.

To start front panel emulation,

1.From the PC, open Program Manager from Windows.

2.Double click on the Front Panel icon that appears after the Front Panel Emulation program is installed on the PC. The Front Panel window opens.

3.Double click on the Front Panel icon that appears in the Front Panel window. The Front Panel Emulation screen appears.

4.Enter the Com Port and Speed from the drop-down selection list boxes.

The Com Port field needs to contain the actual communications port name as recorded in the Windows information file (INI).

The Speed field needs to contain one of the following communications speeds: 1200, 2400, 4800, 9600, 14400, 19200, or 38400 and should match the DSU/CSU's COM port configuration.

5.Choose either a Local (for near-end DSU/CSU) or Remote (for far-end DSU/CSU) destination.

6.If you chose a Local destination, click on the Execute button. If you chose a Remote destination, enter the telephone number of the far-end DSU/CSU in the Phone Number field, then click on the Dial button.

7.The front panel of the selected DSU/CSU appears on the PC.

NOTE

When using Front Panel Emulation, no LEDs are shown on the PC's screen; you must use the Stat command procedure to get LED information (see the Displaying LED Conditions section in Chapter 3, Operation).

G-2 January 1997 3160-A2-GB21-50