Paradyne 3160-A2-GB21-50 Setting the IP Address

Operation
3-153160-A2-GB21-50 January 1997
The example shown below assumes that the COM port
is being used as the link to the SNMP or Telnet system.
To select the COM port as the SNMP or Telnet link,
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the key until the
User selection appears on the screen.
5. Select User.
F1
Edit:
Chan Gen User
F2 F3
6. Press F1 (Next) until the Com Use configuration
option appears.
7. Select Mgmt to configure the COM port as the
SNMP or Telnet link.
F1
Com Use:
Next Mgmt ASCII
F2 F3
Setting the IP Address
The IP address is the address used by the SNMP or
Telnet system to access the DSU/CSU (see Appendix F,
IP Network Addressing Scenarios). For DSU/CSUs using
PPP, the IP address can be negotiated if the network
device (e.g., router or SNMP manager) supports such
negotiation. The IP address is composed of four fields
with three digits per field (xxx.xxx.xxx.xxx).
The IP address is set for the MODEM port, the COM
port, or the AUX port (with LAN Adapter or daisy chain),
depending on which one has been chosen as the SNMP or
Telnet communication link. The example below assumes
that an IP address of 010.155.111.222 is being set for the
COM port. You can use the same principles to assign any
value (between 000 and 255 for each digit field) to other
ports.
To assign an IP address to the COM port,
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the key until the
Mgmt selection appears on the screen.
5. Select Mgmt.
F1
Edit:
User Alarm Mgmt
F2 F3
6. From the Mgmt Config screen, select Gen.
F1
Mgmt Config:
Gen Trap
F2 F3