Paradyne 3160-A2-GB21-50 Deactivating the Alarm Relay for Carrier-Mounted, Resetting the DSU/CSU, Download Operations

Operation
3-433160-A2-GB21-50 January 1997
Deactivating the Alarm Relay
for Carrier-Mounted
DSU/CSUs
The Alarm Cut-off command forces a deactivation of
the alarm relay on the 3000 Series Carrier during an alarm
condition. Since this function only affects the 3000 Series
Carrier, it is only available for carrier-mounted
DSU/CSUs. The alarm relay function must first be
enabled by the Alarm Relay configuration option (refer to
Appendix C, Configuration Options).
To deactivate the alarm relay,
1. From the top-level menu screen, press the key
until the Ctrl selection appears on the screen.
2. Select Ctrl.
3. From the Control screen, select ACO.
F1
Control:
ACO Rel LED
F2 F3
4. The Command Complete screen appears.
F1
Alarm Cut-Off:
Command Complete
F2 F3
Resetting the DSU/CSU
Use the Reset command to perform a power-on reset of
the DSU/CSU.
To reset the DSU/CSU,
1. From the top-level menu screen, press the key
until the Ctrl selection appears on the screen.
2. Select Ctrl.
3. From the Control screen, press the key until
the Reset selection appears on the screen.
4. Select Reset.
F1
Control:
ClrReg Reset
F2 F3
5. From the Device Reset screen, press F1 to initiate
a reset of the DSU/CSU (the power-up sequence
screen appears). Press F2 instead to return to the
Control screen without initiating a reset.
F1
Device Reset:
Yes No
F2 F3
Download Operations
NOTE
The Download command is for
use by service personnel only.
Loss of primary data could result
from improper use.