Pioneer AVH-P3100DVD Available accessories Digital Signal Processor, Using the position selector

	Section
Available accessories	19

Digital Signal Processor

Introduction of DSP adjustments

1

You can use this unit to control multi-channel processor (DEQ-P8000), which is sold sepa- rately.

1DSP display

Shows the DSP function names.

By carrying out the following settings/adjust- ments in the order shown, you can create a fi- nely-tuned sound field effortlessly.

1Setting the speaker setting

2Using the position selector

3Auto TA and EQ (auto-time alignment and auto- equalizing)

4Adjusting the time alignment

5Adjusting the speaker output levels using a test tone

6Selecting a cross-over frequency

7Adjusting the speaker output levels

8Adjusting 3-band parametric equalizer

1Touch AV Menu and then touch DSP Menu to display the DSP function names.

The DSP function names are displayed and

operable ones are highlighted.

# To go to the next group of function names,

touch b.

# To return to the previous group of function

names, touch a.

# When playing discs recorded with more than

96kHz sampling frequency, you cannot use audio functions. Also, equalizer curve setting, Position, Auto EQ and Auto TA will be canceled.

#When playing discs recorded with more than

96 kHz sampling frequency, audio is outputted from front speakers only.

#When selecting FM as the source, you cannot switch to Source Level Adjuster.

#When playing other than the DVD disc, you cannot switch to Dynamic Range Control.

#When neither Front-L nor Front-R is selected in Position, you cannot switch to

Time Alignment.

#When both the center speaker and the rear speaker are set to OFF in the speaker setting, you cannot switch to Dolby Pro Logic II.

2Touch ESC to return to the ordinary dis-

play.

# To return to the previous display, touch Back.

Using the position selector

One way to assure a more natural sound is to accurately position the stereo image, putting you right in the center of the sound field. The position selector function lets you automati- cally adjust the speaker output levels and in- serts a delay time to match the number and position of occupied seats. When used in con- junction with the SFC, the feature will make the sound image more natural and offer a pa- noramic sound that envelops you.

1Touch Position on the DSP function menu.

2Touch c/d/a/b to select a listening po- sition.

Touch one of these, c/d/a/b, to select a lis- tening position as listed in the table.

Key	Display	Position
c	Front-L	Front seat left
d	Front-R	Front seat right
a	Front	Front seats
b	All	All seats

#To cancel the selected listening position, touch the same key again.

Available accessories

En 83