
Chapter
02
Basic operation
Connecting and | 3 Connect your iPod. |
disconnecting iPod |
|
CAUTION
!To prevent data loss and damage to the sto- rage device, never remove it from this naviga- tion system while data is being transferred.
!If data loss or corruption occurs on the sto- rage device for any reason, it is usually not possible to recover the data. Pioneer accepts no liability for damages, costs or expenses arising from data loss or corruption.
Connecting your iPod
Using the USB interface cable for iPod en- ables you to connect your iPod to the naviga- tion system.
pFor connection, USB interface cable for iPod
1Detach the supplied USB cable after checking that no data is being accessed.
2Connect the USB interface cable for iPod to both USB connector and AV input.
USB interface cable for iPod
pFor more details about iPod compatibility
with this navigation system, refer to the in- formation on our website.
pConnection via USB hub is not available.
Disconnecting your iPod
%Pull out the USB interface cable for iPod
after checking that no data is being ac- cessed.
Flow from startup to termination
1 Start the engine to boot up the system. After a short pause, the navigation splash screen comes on for a few seconds.
p To protect the LCD screen from damage, be sure to touch the touch panel keys only with your fingers. (Keep the use of other in- struments at a minimum, and only in cases in which the touch panel calibration is ne- cessary.)
USB interface cable for iPod
2Turn off the vehicle engine to termi-
nate the system.
The navigation system is also turned off.
14
En