DA700/DA750 Features and Adjustments • 3
Setting Up A Job (continued)
9.Print a Test Piece
1.Make sure material is loaded properly. (Or you can use a single test piece if you'd like to check that your setup adjustments are okay.)
2.Turn the printer ON. The ON/OFF switch is located on the interface panel at the rear of the machine.
Display
On Line
Test Envelope
3.Press the ON LINE button on the printer control panel until the LCD display reads OFF LINE.
4.Press the Test Envelope button. A single envelope will feed and a sample address should print.
5.Check the print quality. If it's not what you want, adjust the media thickness knob (page
When you're satisfied with your setup adjustments, you're ready to run the job. The next chapter explains how to use the printer with your computer.
SV61027 Rev. D |