3 • DA700/DA750 Features and Adjustments

Setting Up A Job (continued)

6. Load Material

Once your printer is set up, you can load material and make a test print.

To avoid misfeeds, follow these instructions:

1.Make sure the input area is free of dust and other matter.

2.Take a manageable amount of material and while holding it as shown, fan all sides of the material to separate each piece. This step helps keep misfeeds to a minimum.

3.Tamp the material on a flat surface, making sure that the stack is square.

4.Shingle the stack as you load it into the input area. Load envelopes so the side to be printed aces up. Flaps should be down and oriented away from the feed roller (flaps trailing). Position the right edge of the envelopes flush against the rear wall.

Begin with just a few envelopes to start the stack and get the proper contour, then add several more pieces. Then add the remainder of the stack.

5.Adjust the position of the media thickness knob as described on the next page.

3-16

SV61027 Rev. D

Page 44
Image 44
Pitney Bowes DA700, DA750 manual Load Material, To avoid misfeeds, follow these instructions