Pitney Bowes DA700, DA750 manual Set the Feed Angle, To make the adjustment

3 • DA700/DA750 Features and Adjustments

Setting

Up A Job (continued)

3. Set the Feed Angle

The height of the wireframe input stacker depends on the type of material you're running:

•Heavy material—adjust to a low angle

•Standard material—adjust to the center (45 degree angle)

•Light material—adjust to a high angle

To make the adjustment:

1.Unlock the knob on the wireframe slide by turning counter clockwise.

2.Move the wireframe up or down as required by sliding the retaining knob.

Lock

Scale

3.Turn the lock knob clockwise to secure the wireframe.

NOTE: Center line of the knob aligns with relative number of the scale. Refer to the scale on following page.

3-12 SV61027 Rev. D