Pitney Bowes DA750, DA700 manual Position the Feed Fence, To position the fence

DA700/DA750 Features and Adjustments • 3

Setting Up A Job (continued)

5. Position the Feed Fence

Your printer comes with two feed fences—a long one and a short one. Use the long fence for #10 envelopes and larger materials. Use the short fence for materials smaller than a #10 envelope.

It is important that the sliding fence not be adjusted tight against the media.

To position the fence:

1.Place a sample piece or trial stack of material in the input area.

2.Slide the fence until it almost touches the stack of material.

3.Check that there's about 1/16" clearance (the thick- ness of a dime) between the fence and the stack.

NOTE: Proper clearance is important. If you push the fence tight up against the stack, it could retard feeding and cause jams. If the clearance is too great, pieces could skew as they feed into the printer.

Adjust Sliding Fence to media width.

SV61027 Rev. D 3-15