Command Line Interface (CLI)

AP-4000 Series User Guide

CLI Monitoring Parameters

Configure a Security Profile with 802.11i Security Mode

[Device-Name]>set secprofiletbl <index> secmode 802.11i rekeyint <value> status enable

Example:

[Device-Name]>set secprofiletbl 7 secmode 802.11i rekeyint 900 status enable

Configure a Security Profile with 802.11i-PSK Security Mode

[Device-Name]>set secprofiletbl <index> secmode 802.11i-psk passphrase <value> status enable

Example:

[Device-Name]>set secprofiletbl 8 secmode 802.11i-psk passphrase 12345678 status enable

CLI Monitoring Parameters

Using the show command with the following table parameters will display operating statistics for the AP (these are the same statistics that are described in the Monitoring section).

staticmp: Displays the ICMP statistics.

statarptbl: Displays the IP ARP Table statistics.

statbridgetbl: Displays the Learn Table.

statiapp: Displays the IAPP statistics.

statradius: Displays the RADIUS Authentication statistics.

statif: Displays information and statistics about the Ethernet and wireless interfaces.

stat802.11: Displays additional statistics for the wireless interfaces.

statethernet: Displays additional statistics for the Ethernet interface.

statmss: Displays station statistics and Wireless Distribution System links.

statmesh: Displays statistics about the Mesh network.

Parameter Tables

Objects contain groups that contain both parameters and parameter tables. Use the following Tables to configure the Access Point. Columns used on the tables include:

Name - Parameter, Group, or Table Name

Type - Data type

Value - Value range, and default value, if any

Access = access type, R = Read Only (show), RW = Read-Write (can be “set”), W = Write Only

CLI Parameter - Parameter name as used in the Access Point

Access Point network objects are associated with Groups. The network objects are listed below and associated parameters are described in the following Parameter Tables:

System Parameters - Access Point system information

Inventory Management Information - Hardware, firmware, and software version information

Network Parameters - IP and Network Settings

IP Configuration Parameters - Configure the Access Point’s IP settings

DNS Client for RADIUS Name Resolution - Configure the Access Point as a DNS client

DHCP Server Parameters - Enable or disable dynamic host configuration

SNTP Parameters - Configure

184

Page 184
Image 184
Proxim AP-4000 CLI Monitoring Parameters, Parameter Tables, Configure a Security Profile with 802.11i Security Mode, 184