Command Line Interface (CLI) |
|
Parameter Tables |
|
|
|
–Link Integrity Parameters - Monitor link status
•Interface Parameters - Configure Wireless and Ethernet settings
–Wireless Interface Parameters
—Channel Blacklist Parameters - View and configure blacklisted channels
—Wireless Distribution System (WDS) Parameters - Configure the WDS partnerships
–Wireless Interface SSID/VLAN/Profile Parameters - Configure the SSIDs, VLANs, and security modes for each interface. Up to 16 SSIDs per wireless interface are supported; different security settings can be applied to each SSID, and a unique VLAN can be configured per SSID.
–Ethernet Interface Parameters - Set the speed and duplex of the Ethernet port.
–Mesh Network Parameters - Configure the Mesh network.
•Management Parameters - Control access to the AP’s management interfaces
–SNMP Parameters - Set read and read/write passwords
–HTTP Parameters - Set up the graphical web browser interface. If required, enable SSL and configure the SSL certificate passphrase.
–Telnet Parameters - Telnet Port setup
–Serial Port Parameters - Serial Port setup
–RADIUS Based Management Access Parameters - Configure RADIUS Based Management Access for HTTP and Telnet access.
–SSH Parameters - Enable SSH and configure the host key.
–TFTP Server Parameters - Set up for file transfers; specify IP Address, file name, and file type
–IP Access Table Parameters - Configure range of IP addresses that can access the AP
–Auto Configuration Parameters - Configure the Auto Configuration feature which allows an AP to be automatically configured by downloading a configuration file from a TFTP server during boot up.
•Filtering Parameters
–Ethernet Protocol Filtering Parameters - Control network traffic based on protocol type
–Static MAC Address Filter Table - Enable and disable specific addresses
–Proxy ARP Parameters - Enable or disable proxy ARP for wireless clients
–IP ARP Filtering Parameters - Control which ARP messages are sent to wireless clients based on IP settings
–Broadcast Filtering Table - Control the type of broadcast packets forwarded to the wireless network
–TCP/UDP Port Filtering - Filter IP packets based on TCP/UDP port
•Alarms Parameters
–SNMP Table Host Table Parameters - Enter the list of IP addresses that will receive alarms from the AP
–Syslog Parameters - Configure the AP to send Syslog information to network servers
•Bridge Parameters
–Spanning Tree Parameters - Used to help prevent network loops
–Storm Threshold Parameters - Set threshold for number of broadcast packets
–Intra BSS Subscriber Blocking - Enable or disable peer to peer traffic on the same AP
–Packet Forwarding Parameters - Redirect traffic from wireless clients to a specified MAC address
•RADIUS Parameters
–Set RADIUS Parameters - Configure RADIUS Servers and assign them to VLANs.
•Security Parameters - Access Point security settings
–MAC Access Control Parameters - Control wireless access based on MAC address
–Rogue Scan Configuration Table - Enable and configure Rogue Scan to detect Rogue APs and clients.
–802.1X Parameters - Configure 802.1X Supplicant Timeout parameter
