Sender Settings

Sender Settings

Use this function to set sender information.

If the sender's e-mail address is registered in the destination list, the sender can receive transmission results by e-mail.

Also, if you enable the Stamp Sender Name, the registered sender's name (user

2

name) appears on the receiver's sheet, lists, and report.

Important

To receive transmission results by e-mail, the optional printer/scanner unit must be installed.

In the destination list, register senders, specify their e-mail addresses, and register as [Sender Only] or [Dest. & Sender] in advance using “Address Book Management” in “System Settings”.

If user authentication is set, the user logged in is set as sender. The transmis- sion result is sent to the logged-in user's e-mail address.

A Place the original, and then select the scan settings you require. B Press [TX Mode].

C Select [Sender Settings] using {U} or {T}, and then press the {OK} key.D Select a sender.

If a destination protection code is set, the entry screen appears. Enter the protection code for destination using the number keys, and then press the {OK} key.

93