
If the optional tray is not installed, the tray options on the screen is grayed out.
Changing the default settings
You can set the default values for copy, fax, email, scan and paper all at once.
1.Press Machine Setup on the control panel.
2.Press Admin Setting.
3.When the login message appears, enter password with number keypad and press OK. (See "Setting the authentication password" on page 30.)
4.Press the General tab > Default Settings > Default Option.
5.Press the function you want to change, and change its settings.
For example, if you want to change the default setting of the brightness
& darkness for a copy job, press Copy > Darkness and adjust the brightness & darkness.
6.Press OK.
Using the SetIP program
This program is for the network IP setting using the MAC address which is the hardware serial number of the network printer card or interface. Especially, it helps the network administrator set several network IPs at the same time.
The following procedure is based on windows XP. If you use Macintosh or Linux OS, see Software section
• You can only use SetIP program when your machine is connected to a network.
•The following procedure is based on the Windows XP operating system. If you are using Macintosh or Linux, See Software section.
•If you are in a
•You can only use IPv4 setting for SetIP.
Installing the program
1.Insert the driver CD provided along with your machine. When the driver CD runs automatically, close the window.
2.Start Windows Explorer and open the X drive. (X represents the name of your
3.Double-click Application > SetIP.
4.Open the folder of the language you plan to use.
5.
6.Follow the onscreen instructions to complete the installation.
Setting network values
1.Print the machine’s network configuration report to find your machine’s MAC address. (See "Printing a report" on page 82.)
2.From the Windows Start menu, select All Programs > Samsung Network Printer Utilities > SetIP.
3.Click to open the TCP/IP configuration window.
4.Enter the network card's MAC address, IP address, subnet mask, default gateway, and then click Apply.
When you enter the MAC address, enter it without a colon(:).
5.Click OK, and then the machine prints the network information. Check all the settings are correct.
6.Click Exit.
31