Samsung ScanThru window
The controls of the Samsung ScanThru window are described below.
Image Type: Selects an image type used for | Resolution: Selects a resolution used for scanning. | ||||
scanning. | Save Mode: | ||||
|
| ||||
Scan To OCR: If this button is checked, the | Minimize Time mode results in less image storage time, while | ||||
scanned document will be automatically passed to | increasing the disk space required to store an image. | ||||
OCR programme for text recognition. | Minimize Size mode decreases disk space occupied by stored | ||||
Brightness/Contrast: Adjust the brightness to | images , while increasing storage time. Save Mode selection is | ||||
available only when you are scanning images that are stored in | |||||
make the image lighter or darker. Also, adjust the | |||||
Samsung ImageThru. This selection is disabled when scanning | |||||
contrast to sharpen the image definitions. | |||||
to Fax or to | |||||
|
| ||||
|
| ImageThru. | |||
|
|
|
|
| |
|
|
|
|
| |
Sample picture
The dotted rectangle
defines the size and position
of image area where the
scanned picture should appear.
Using SmarThru
Resets all the controls to their default values.
Starts scanning. The scanned image will be saved in Incoming folder of Samsung ImageThru.
Scans an image at 75 dpi resolution. This is useful for preliminary testing of scanner setup etc.
The scanned image will replace the picture in the sample picture area.
Exits Samsung ScanThru.
Brings up the help file.
Image Area: Allows you to select the size of image area. You can also change the size by resizing the image area marquee in the sample picture area.
Left, Top: These settings define a position of the top left corner of the image area. Enter the desired value. (Don’t forget to set the appropriate measurements unit using the Unit radio buttons.) You can also change the start position by dragging the image area marquee. Set the cursor inside the marquee (the cursor turns into a
Scanning with Samsung ScanThru 3.5
