Savin G1619 manual Broadcasting Sequence, Automatic Redial, Broadcasting Checking Progress

More Transmission Functions

Broadcasting Sequence

If you dial several destinations for the same message (Broadcasting), the messages are sent in the order in which they were dialed. If the fax message could not be transmitted to a destination, the machine redials that destination after the last destination specified for Broadcasting. For exam- ple, if you specify four destinations A through D for broadcasting, and if the lines to destinations A and C are busy, the machine dials the destina- tions in the following order: A, B, C, D, A, and C.

Automatic Redial

If a fax message could not be trans- mitted because the line was busy or an error occurred during transmis- sion, redialing is done 4 times at 5 minutes intervals (these figures vary according to which country you are in).

If redialing fails after four redials, the machine cancels the transmission and 3 prints the Communication Result Re-

port or Communication Failure Re- port.

Sending a Fax Message Immediately

To send a fax message immediately, use Immediate Transmission. If you have just set up an original for broad- casting, Immediate Transmission will interrupt the current communication.

Your message will not be sent until previously queued files have been sent.

Broadcasting : Checking Progress

To check which destinations the fax message has been sent to so far, print the TX file list.

Batch Transmission

If you send a fax message by Memory Transmission and there is another fax message waiting in memory to be sent to the same destination, that message is sent along with your mes- sage. Several fax messages can be sent with a single call, thus eliminating the need for several separate calls. This helps save communication costs and reduces transmission time.

Fax messages for which the transmis- sion time has been set in advance are sent by Batch Transmission when that time is reached.

Note

❒You can switch this function on or off with the User Parameters. See p.58 “User Parameters” (Switch06, Bit4).

23