Savin G1619 manual Printing the User Parameter List

Key Operator Settings

HPress the {OK} key.

For a list of the switches and set- tings, see p.58 “User Parameters”.

Use the User Parameters table to look up the number of the switch that you want to change, and then press the 0 or 1 key to display the number of the switch.

The bits are numbered 7~0. To change a setting, press the corre- sponding number key to toggle the setting between "0" and "1"

Key to	7	6	5	4	3	2	1	0
Press
SW 00:	1	0	0	0	0	1	1	0

6	For example, if you want to change
	the setting at bit 7, press the 7 num-
	ber key to toggle the setting be-
	tween "1" and "0".

I When you are finished making adjustments, press the {OK} key.

J Press the {User Tools} key to re- turn to the standby display.

Printing the User Parameter List

Print this list to see the current User Parameter settings.

A Press the {User Tools} key.

B Press 0 or 1 until " 4. Fax Fea- tures " is displayed.

CPress the {OK} key.

D Press 0 or 1 until " 4. Key Op. Tools " is displayed.

EPress the {OK} key.

F Press 0 or 1 until " 3. User Pa- rameters " is displayed.

GPress the {OK} key.

H Press the 0 or 1 key until " 2. Print List " is displayed.

IPress the {OK} key.

J Press the {Start} key to print the list.

Note

❒If you press the {Cancel} key be- fore printing starts, the list will not be printed and the display shown in step H appears again.

62