Accessories

Accessories Safety

1.Use only accessories listed in this sec- tion. Use of any other accessory or attach- ment might increase the risk of injury to you or others.

2.Read and follow instructions that come with accessory.

3.Do not install accessories on both ends of arbor shaft at same time.

4.Do not use twist drill bits longer than 7" because they can bend and break.

5.Use a spade type drill 1" or smaller in diameter for drilling only wood or plastic.

6.Do not use reduced shank drills.

7.Remove blade wrenches before turn- ing saw on.

_, DANGER

Grinding wheels, abrasive or cut off wheels, or wire wheels can break

explosively and throw pieces. You can be blinded or receive a life

threatening puncture wound. Do not use grinding wheels, abrasive or cut off wheels, or wire wheels.

,_ WARNING

When using accessory shaft, ex- posed arbor shaft can pull in cloth-

ing, hair or jewelry as it rotates. Broken bones and severe cuts could

OCCUr.

Follow personal safety instructions. Locate arbor shaft under radial arm: lock blade carriage in out-rip posi- tion, then bevel motor to -90°.

Information for Dado

1. Put inside loose collar on arbor shaft

first, then install dado. Tighten blade nut directly against outside surface of dado.

2.Saw arbor is designed for dado up to 13%"wide. Use of wider dado could cause

dado and blade nut to spin off. To make larger than 13q6"wide cut, take several pas- ses with dado.

3. To avoid excessive load on motor when making a 13qC wide cut, limit depth of cut to W' in one pass.

Information for Edging

Edging is the use of a dado or molding

head in the horizontal position. Edging re- quires the use of a molding head guard

(see Accessories List) and an auxiliary fence (see Cutting Aides).

1.Use molding head guard for edging

with molding head and dado blade. Fol-

low instructions that come with guard. Do not edge with a blade.

,_ DANGER

Edging without a guard can bring

hands and fingers too close to blade. Hands, fingers and arm could be cut off. Buy, install, and follow instructions for molding head guard.

,_ DANGER

Blade cannot be guarded in horizon-

tal position. Edge with guarded molding head or dado. Do not edge with blade.

2. Install auxiliary fence (see Cutting Aides) to allow positioning of cutting tool behind fence.

3.Whenever possible, edge with arm locked at indexed 0 ° miter, so blade car- riage is more likely to lock firmly.

72

Page 72
Image 72
Sears 113.197611, 113.197511, 113.197411 owner manual Accessories Safety, Information for Dado, Information for Edging