Sharp FO-IS115N Option Settings, When this is done, unless you press the, key before dialing

Option Settings

PBX	If you are on a PBX, use this setting to set up automatic
CONNECTION	connection to an outside line when dialing by automatic dialing.
	(When this is done, unless you press the		SPEAKER
			key before dialing
	to dial manually, you will always automatically connect to an
	outside line when you dial on the machine; there will be no need to
		R
	press the flash key ( ) or dial a prefix in order to dial out.)
	1. Press	(YES) to enable the PBX connection setting. (
	(NO) should be selected if you are not on a PBX.)
	2. Press	(FLASH) if you connect to an outside line by

pressing a flash key (	R	(ID) if you
	on the machine). Press

connect to an outside line by dialing a particular number (a prefix or ID number).

3.If you selected ID in step 2, enter the number that you dial to connect to an outside line (maximum of 3 digits) and then press

	START .
DIAL TONE	Press	(YES) to have the machine verify the presence of a
DETECTION

dial tone on the line before automatic dialling. Press (NO) to turn this function off.

Note: If you select YES and find that the machine is unable to dial, change the setting to NO.

Initial setting: NO

KEY TONE Press (ON) to have the machine sound a beep each time a

key is pressed on the operation panel (this confirms that the key

has been correctly pressed). Press (OFF) to turn off the beep sound.

Initial setting: ON

106