Sharp MX-M232D Copying from the SPF/RSPF, Press the Start key to begin, Copy is delivered to

MNO

WXYZ

@.-_

AD-END

COPY FUNCTIONS

5	Press the [START] key ( ) to begin	•	The centre tray can hold a maximum of
		Note	250 sheets (150 sheets when the job
	copying.		separator tray kit is installed).
	The copy is delivered to	•
			About one minute after copying ends,
	the paper output tray.		"Auto clear" (p.22) activates and restores
			the copy settings to the default settings.
			The setting for "Auto clear" can be
			changed in the system settings. (p.118)
		•	To cancel a copy job in progress, press
			the [C] key.
		•	Differences in copy conditions may cause
			the position of the printed copy image to

vary even the copies are of the same original on the same paper. For more information, see "Points concerning the position of the printed copy image" on (p.32).

Copying from the SPF/RSPF

1 Make sure that an original has not been left on the document glass. Close the SPF/RSPF.

2 Adjust the original guides to the size of the original(s).

3 Set the original(s) face up in the document feeder tray.

The original size appears in the display and the most suitable paper size is automatically selected. Insert the stack into the document feeder tray until it stops.

•If the original is a non-standard size or the Note size was not detected correctly, see

"SELECTING THE ORIGINAL SIZE" (p.35).

•If the auto paper select function has been disabled in the system settings (p.123), use the [PAPER SELECT] key to select the desired paper size.

•To copy onto paper of a different size, press the [PAPER SELECT] key and select the desired paper size.

•Paper in a different orientation from the original may be selected if the auto paper select or auto image function has been selected. In this case, the image of the original will be rotated.

•To use the bypass tray, select it manually.

•Do not place originals of different sizes together in the document feeder tray. This may cause misfeeds.

Do not place originals of different sizes Note together in the document feeder tray. This

may cause misfeeds.

3

4 Set the number of copies.

5 Press the [START] key () to begin copying.

The copies are delivered to the centre tray.

The default output mode for

copying from the SPF/RSPF is sort mode. (p.49)

The output mode can be changed using the automatic

sort selection setting in the system settings. (p.123)

•The centre tray can hold a maximum of Note 250 sheets (150 sheets when the job

separator tray kit is installed).

•About one minute after copying ends, "Auto clear" (p.22) activates and restores the copy settings to the initial settings. The duration of time after which "Auto clear" clears the copy settings can be changed in the system settings. (p.118)

•To stop copying in the middle of a run, press the [C] key. If you find it difficult to remove the original from the document feeder tray, open the feeding roller cover before removing the original. If you pull out the original without opening the feeding roller cover, the original may become dirty.

30