Sharp MX-M232D, MX-M182 TWO-SIDED Copying Using the Bypass Tray, Place original B as shown below

TWO-SIDED COPYING USING THE BYPASS TRAY

To perform manual two-sided copying, follow these steps.

Example: Copying originals A and B onto each side of one sheet of paper

Original A Original B Copy

If you are using the MX-M182D/MX-M202D/ MX-M232D

The MX-M182D/MX-M202D/MX-M232D is equipped standard with an automatic two-sided copying function that automatically turns over the paper. If paper in "Paper that can be used for automatic 2-sided printing (MX-M182D/MX-M202D/MX-M232D)"(p.23) is used, this enables easier two-sided copying than using the bypass tray. See "AUTOMATIC TWO-SIDED COPYING (MX-M182D/MX-M202D/MX-M232D)" (p.41).

1 Copy original A.

3 Turn the copy of original A over, and

without changing the position of the	3
edge closest to you, insert it in the
bypass tray.
Insert the paper all the

1

1

way in.

Copy of original A

1

Copy of original A

Original A

1

Original A

1 2

Original B

1

2

Original B

1

Copy of original A

1

Copy of original A

2 Place original B as shown below.

	Vertically-oriented
	original:
	If the original is oriented
2	vertically, place it in the
	same orientation as
Original B	original A.

• Copies made on the back side of paper Note should always be made one sheet at a time

using the bypass tray.

2

Original B

Horizontally-oriented original:

If the original is oriented horizontally, place it with the top and bottom and left and right sides reversed with respect to the placement of original A.

•Straighten curled or wavy paper before using it. Curled paper may cause misfeeds, creases, or a poor-quality image.

•After placing the original, be sure to close the document cover/SPF/RSPF. If left open, parts outside of the original will be copied black, causing excessive use of toner.

4 Select the bypass tray with the [PAPER SELECT] key, and then press the [START] key ( ).

The copy is delivered to the paper output tray.

46