Sharp MX-M232D, MX-M182D manual Erasing Shadows around the Edges of a Copy, Erase, Centre, ~20

(Erase Copy)

COPY FUNCTIONS

ERASING SHADOWS AROUND THE EDGES OF A COPY

●This feature is used to erase shadows that appear around the edges of copies of books and other thick originals.

(EDGE ERASE)

●The feature can also erase the shadow that appears down the centre of books and other originals that open up.

(CENTRE ERASE)

●The factory default setting for the width of the erasure is approximately 10 mm (1/2"). The width can be changed in the system settings. (p.121)

Edge erase

A A

Centre erase

A B A B

Edge + Centre erase

A B A B

• Five selections are available for the erasure width: 0 mm, 5 mm, 10 mm, 15 mm, 20 mm (0", 1/4", 1/2", 3/4", 1"). (The default setting is 10 mm (1/2").)

• Centre erase / Edge + Centre erase cannot be used in combination with dual page copy (p.47).
• Edge erase cannot be used in combination with 2 in 1 / 4 in 1 copy (p.51).
• Edge erase cannot be used when paper is fed from the bypass tray.
	3
• Edge erase cannot be used in combination with card shot (p.56).
• Edge erase cannot be used when copying a special size original.
• Note that if the width of the erasure is too large, the edge of the image may be partially erased.
• The default setting for the erasure width can be changed. (p.121)

1 Place the original in the document feeder tray or on the document glass.

2 Press the [SPECIAL FUNCTION] key and select "SPECIAL MODES" with the [ ] or [ ] key.

DATA	SPECIAL	SPECIAL	FUNCTION
ON LINE		ID CARD	COPY
	FUNCTION
		SPECIAL	MODES
DATA	SCAN COLOUR MODE RESOLU	ORIG. SIZE		ENTER
LINE	COPY EXPOSURE PAPER SE
		PAPER SIZE		SET

The function screen appears with "SPECIAL MODES" selected.

3 Press the [OK] key.

GHI	SPECIAL MODES
BACK OK
PQRS	MARGIN SHIFT
	ERASE
PY	DUAL PAGE COPY
The special modes	[OK]:ADJUST
AN
screen will appear.

4 Select "ERASE" with the [ ] or [ ] key.

PQ	SPECIAL	MODES
	MARGIN SHIFT
LEX SCAN	ERASE
ED COPY	DUAL	PAGE COPY
ACC
LEX SCAN	[OK]:ADJUST
The edge erase settings
screen will appear.
5 Press the [OK] key.
OK	ERASE
	OFF
	EDGE
	CENTRE
The edge erase settings	10 mm	(0~20)
screen will appear.

6 Select the desired erase mode with the [] or [] key.

"EDGE", "CENTRE" or "EDGE+CENTRE" can be selected.

54