Sharp MX-M182D, MX-M202D manual Loading Paper, Loading the paper tray, Push the pressure plate down

BEFORE USING THE MACHINE

LOADING PAPER

Make sure that the machine is not copying or printing, and then follow these steps to load paper.

Loading the paper tray

1 Gently lift and pull out the paper tray until it stops.

4 Load paper into the tray.

• Open the package of the paper and load it without fanning the paper.

• Make sure the stack of paper is straight before loading it.

2 Adjust the plates in the tray to the length and width of the paper.

Plate B		• The plate A is a slide-type
		guide. Grasp the locking knob
		on the guide and slide the
		guide to the indicator line of
	Plate A	the paper to be loaded.

•The plate B is an insert-type guide. Remove it and then insert it at the indicator line of the paper to be loaded.

•When using 11" x 17" sized paper store the plate B in the slot at the left front of the

paper tray.

3 Push the pressure plate down.

Push the centre of the pressure plate down until it locks into place.

2

•	Do not load paper higher than the line on
Note	the tray (up to 250 sheets).

•Do not add paper to the loaded paper. It may cause multiple feed of paper.

•A5 (5-1/2" x 8-1/2") can be used in the upper paper tray but cannot be used in other trays (including trays in optional paper feeding unit).

5 Gently push the paper tray into the machine.

• If you loaded a different size of paper than Note was loaded previously in the tray, go to

"CHANGING THE PAPER SIZE SETTING OF A TRAY" (p.26).

•When misfeed occurs, rotate the paper 180 degrees and reload it.

•Straighten curled paper before using it.

For how to load paper, refer to the steps below.

24