COPY FUNCTIONS

USING THE BYPASS TRAY TO COPY A SPECIAL SIZE ORIGINAL

When the bypass tray is being used for copying and an original that is placed on the document glass is detected as being a special size, the display will prompt the user to set the original size. To make a copy in this type of situation, follow the steps below.

1 Load paper in the bypass tray and place the original on the document glass.

2 Touch the [PAPER SELECT] key and then select the bypass tray.

RE PAPER SELECT COPY RATIO AUTO IMAGE

[OK]:ORIG. SIZE

AM RESOLUTION ADDRESS

BROADCAST O

ODE RESOLUTION ADDRESS

FORMAT O

 

ENTER

AUTO

100%

EXTRA

A message will appear asking you whether you wish to set the original size or make the copy without setting it. To make a copy without setting the original size, press the [START] key ( ). To set the original size, go to step 3.

If you load thick paper in the bypass tray, Note press the [PAPER] key until "EXTRA" is

highlighted. The paper type is set to thick paper. The setting is cleared when "Auto clear" works or the [CA] key is pressed.

For restrictions on paper types and weights, see "PAPER" (p.23).

[OK]:ORIG. SIZE ENTER

 

AUTO

 

100%

 

EXTRA

3 Press the [OK] key.

GHI

ORIG. SIZE ENTER

BACK OK

PQRS

AB

 

A4R

PY

A5

AN

SIZE INPUT

 

The original size selection screen appears with "SIZE INPUT" selected.

4 Select AB or inches with the [] or [] key, and then select the original size with the [] or [] key.

PQ

ED COPY

LEX SCAN

LEX SCAN

ACC

5 Press the [OK] key.

If "SIZE INPUT" was selected in step 4:

OK

SIZE

INPUT

 

SIZE(mm)

 

X:

210

 

Y:

148

The size entry screen appears and is ready for entry of the width of the original.

Note

If you selected inches in step 4, the screen will

3

be ready for you to enter the width in inches.

 

 

If other than "SIZE INPUT" was selected in step 4:

 

You will return to the base screen. Go to step 8.

6 Select "X" (width) with the [ ] or [ ] key and enter the width with the [] or [] key, and then do the same for the length (Y).

SIZE INPUT

SIZE(mm)

X: 100

Y: 100

Any number from 64 mm to 432 mm (2-1/2" Note to 17") can be entered for the width, and

any number from 64 mm to 297 mm (2-1/2" to 11-5/8") can be entered for the length.

The entered size is retained until the power is turned off, even if "SIZE INPUT" is selected again and the entry screen of step 5 is displayed.

7 Press the [OK] key.

OK

You will return to the base

 

screen.

8 Press the [START] key ().

MNO

Copying begins.

 

WXYZ

 

@.-_

 

AD-END

 

36

Page 37
Image 37
Sharp MX-M182D, MX-M202D, MX-M232D manual Extra, OKORIG. Size Enter, Size Input