Sharp MX-M182D manual Selecting the Original Size, ORIG. Size Enter Inch, Standard sizes

COPY FUNCTIONS

SELECTING THE ORIGINAL SIZE

If you loaded a non-standard size* original or the original size was not correctly detected, set the original size manually. Perform the following steps after placing the document in the document feeder tray or on the document glass.

Note	* Standard sizes:
	The following sizes can be detected correctly: A3, B4, A4, A4R, A5 (11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/2" x
	11", 8-1/2" x 11"R, 5-1/2" x 8-1/2"). If a non-standard size original is placed (including special sizes), the closest
	standard size may be displayed, or the original size may not appear.

1 Press the [SPECIAL FUNCTION] key.

DATA	SPECIAL	SPECIAL	FUNCTION
ON LINE		ID CARD	COPY
	FUNCTION
		SPECIAL	MODES
DATA	SCAN COLOUR MODE RESOLUT	ORIG. SIZE		ENTER
LINE	COPY EXPOSURE PAPER SE
		PAPER SIZE		SET
The special function

screen will appear.

2 Select "ORIG. SIZE ENTER" from the menu with the [] or [] key.

PQ	SPECIAL	FUNCTION
	ID CARD	COPY
LEX SCAN	SPECIAL	MODES
ED COPY	ORIG. SIZE		ENTER
ACC
LEX SCAN	PAPER SIZE		SET
3 Press the [OK] key.
GHI	ORIG. SIZE		ENTER
BACK OK
PQRS	A3	AB
PY	B4
AN	A4
The original size selection

screen will appear.

4 Select the original size with the [] or [] key.

5 Press the [OK] key.

OK	You will return to the base
	screen and the selected original
	size will appear in the original
	size display.

Selecting an inch original size

6 Select the original size with the [ ] or [] key.

ORIG. SIZE ENTER

INCH

11x17

812 x14 812 x11

To return to selection of AB original sizes, press the [ ] key to return to step 4.

7 Press the [OK] key.

OK	You will return to the base
	screen and the selected original
	size will appear in the original
	size display.
Note	To cancel an original size selection, press
	the [CA] key.

The selected original size is highlighted.

ORIG. SIZE ENTER

AB

A3

B4

A4

•To select an inch original size, press the [] key and go to step 6.

•If you selected "SIZE INPUT", follow steps 4 through 6 of the procedure in "USING THE BYPASS TRAY TO COPY A SPECIAL SIZE ORIGINAL" (p.36) to set the horizontal and vertical dimensions of the original.

35