Sharp MX-M232D, MX-M182 manual Card Shot Default, Default Tray SET, Stream Feeding, Rotation Copy

SYSTEM SETTINGS GUIDE

CARD SHOT DEFAULT

(When the dual function board is installed)

This program is used to set the default dimensions that appear when the card shot size entry screen is displayed.

The factory default settings are 86 mm (3-3/8") for the width (X) and 54 mm (2-1/8") for the length (Y).

1Select the exposure mode with the [ ] or [ ] key.

2If you selected "TEXT" or "PHOTO", set the exposure level with the [] or [] key.

3Press the [OK] key.

Select "CARD SHOT DEFAULT" and press the [OK] key. The following screen will appear.

CARD SHOT DEFAULT

SIZE(mm)

X:

Y:

1Select X or Y with the [ ] or [ ] key and adjust the corresponding default value with the [] or [] key.

2Press the [OK] key.

DEFAULT TRAY SET

This program is used to set which tray is selected by default.

Trays that appear for selection will vary depending on the optional trays that have been installed.

The factory default setting is "TRAY 1".

Select "DEFAULT TRAY SET" and press the [OK] key. The following screen will appear.

DEFAULT TRAY SET

TRAY 1

TRAY 2

TRAY 3

TRAY 4

1Select the tray with the [ ] or [ ] key.

2Press the [OK] key.

STREAM FEEDING

When stream feeding mode is enabled, additional originals which are placed in the SPF/RSPF within 5 seconds after the previous original was fed will be copied automatically. (If more than 5 seconds elapse, the [START] key ( ) must be pressed again.)

This function can be used when scanning originals in copy and scan modes.

The function is initially disabled (factory default setting).

To enable stream feeding, select "STREAM FEEDING" and press the [OK] key so that a checkmark appears in the checkbox.

To disable stream feeding, select "STREAM FEEDING" once again and press the [OK] key so that the checkmark is cleared from the checkbox.

ROTATION COPY

(When the dual function board is installed)

If the orientation of the original does not match that of the paper, the image can be rotated.

Rotation copy operates when automatic paper selection or automatic ratio selection operates. The function is initially enabled (factory default setting).

If the image is both rotated and reduced, the Note position of the copied image will vary

depending on the orientations of the original and the paper.

Original Paper Copy

DEFAULT EXPOSURE

This program is used to select the exposure mode/level that is initially selected when the [EXPOSURE] key is pressed.

The factory default setting is "AUTO".

Select "DEFAULT EXPOSURE" and press the [OK] key. The following screen will appear.

DEFAULT EXPOSURE

AUTO AUTO

TEXT

PHOTO

9

To enable rotation copy, select "ROTATION COPY" and press the [OK] key so that a checkmark appears in the checkbox.

To disable rotation copy, select "ROTATION COPY" once again and press the [OK] key so that the checkmark is cleared from the checkbox.

122