INTERRUPTING A COPY RUN

(Interrupt copying)

A copy run can be temporarily interrupted to allow another copy job to be performed. (Interrupt copying) When the other job is finished, the copy run will resume using the original copy settings.

Interrupt copying is not possible when the document glass is being used for a copy job and "NO SORT" is selected.

When 2 in 1 or 4 in 1 is selected, interrupt copying is not possible.

Sort copying, 2 in 1, and 4 in 1 and automatic two-sided copying cannot be used for an interrupt copy job. Configuring settings in the system settings, use as a scanner, and fax transmission are also not possible.

1 Press the [INTERRUPT] key ( ).

4 Set the number of copies and then press the [START] key ().

 

If the [INTERRUPT] key ( ) is

INTERRUPT

pressed, copying will stop and

 

the settings will temporarily

 

return to the default settings

 

after the copy in progress has

 

been completed.

The INTERRUPT indicator will blink until the current copy run stops.

If you press the [INTERRUPT] key ( ) Note when auditing mode is enabled, "Enter your

account number." will appear in the display. Enter your account number using the numeric keys. The pages copied during interrupt copying will be added to the count of the entered account number. (p.114)

2 When the copy run stops, remove the previous original(s) and place the original(s) of the interrupt copy job.

3 Select copy settings as needed.

MNO

WXYZ

@.-_

AD-END

Note

3

(C)

(B)

(A)

The interrupt copies will be offset from the previous copies. (Offset function)

The offset function can be disabled in the system settings. (p.117)

(A): Copies made before the interrupt copy job

(B): Interrupt copies

(C): Copies made after the interrupt copy job

*This function is not available in some countries and regions.

5 When the copy job is finished, press the [INTERRUPT] key ( ) to end interrupt mode and remove the original(s).

The INTERRUPT indicator will turn off, indicating that the interrupt function is no longer operating. The copy settings will automatically revert to the settings selected for the copy run before the run was interrupted.

6 Replace the previous original(s) and press the [START] key ().

The interrupted copy run will resume.

48

Page 49
Image 49
Sharp MX-M182D, MX-M202D, MX-M232D manual Interrupting a Copy RUN, Replace the previous originals and press the Start key