Each time you make a long distance phone or fax call, the fax machine will automatically route the call through the least expensive carrier based on the downloaded rate information.
Don’t unplug the fax, or the rate data will be lost!
Caution!
If you unplug the fax machine or an interruption occurs in your power supply, the rate data will be erased. If this happens, the highlighted “C” in the display will blink to alert you.
The fax machine will automatically call OpenLCR within the next 24 hours to receive new rate data; however, if you want to use OpenLCR service before that time, you should download the rate table manually as explained on page 29.
♦We recommend that you do not unplug the fax machine on a regular basis (for example at night or on the weekends), as this will result in a large number of calls to OpenLCR and a higher phone bill depending on where you live.
Setting Up and Using OpenLCR
The following table shows marks related to OpenLCR that may appear
in the display. |
| ||
|
|
| Setting2. Up OpenLCR |
Mark | activated and is ready for | ||
Meaning |
| ||
|
| OpenLCR has been |
|
|
| use. |
|
|
|
| |
|
|
|
|
|
| OpenLCR cannot be used |
|
|
| because the rate data has |
|
|
|
| |
|
| been erased. Your fax will |
|
|
|
| |
(Blinking) |
| ||
automatically call OpenLCR |
| ||
|
| within the next 24 hours to |
|
|
| receive new data, or you |
|
|
| can download the data |
|
|
| manually if you need to use |
|
|
| OpenLCR immediately. |
|
|
| See Downloading |
|
|
| (receiving) the rate data |
|
|
| manually on page 29. |
|
The rate data in the fax is no longer correct and the fax cannot connect to OpenLCR to obtain new data. See What to do if “E” appears in the display on page 33.
OpenLCR has been temporarily turned off. See Temporarily turning off OpenLCR below.
Rate data was not yet available when your fax called OpenLCR. Your fax will automatically call OpenLCR again when the rate data is available. Until that time, long distance calls will be routed through your primary carrier.
31
