a)This selector is supplied with models other than UP-51MDU. Set the NTSC/PAL selector to your TV system. To switch the TV system, turn the power off once, then change the setting. If you change the setting with the power on, this mode will not be switched.
b)Two kinds of 75-ohm termination switches are provided; one is for the RGB input and the other is for the composite video signal. Normally set this switch to ON. Set it to OFF if the level of the input signal drops because the signal is divided to additional video equipment other than the printer.
Making Connections for Viewing Images to be Printed
Connect a video monitor to view stored images and to check those to be printed. Connect the required video monitor which will be used in actual printing, using the following diagram as a guide.
Before connecting the video equipment, see “Important safeguards/notices for use in the medical environments” for UP-51MD/51MDU/51MDP on page 2.
NTSC/PAL selector a)
NTSC PAL
to AC IN 
to VIDEO OUTPUT
to RGB/SYNC OUTPUT b)
75-ohm coaxial cable with BNC connectors
to S-VIDEO OUTPUT
Connecting cable (with
DIN 4-pin connectors)
YC-15EV
to S-VIDEO input connector
75-ohm coaxial cable with BNC connectors
| to composite | to wall outlet |
| AC power cord |
| video input |
| (supplied) |
| connector |
| |
to RGB input | Video monitor |
connectors | |
a)This selector is supplied with models other than UP-51MDU. Set the NTSC/PAL selector to your TV system. To switch the TV system, turn the power off once, then change the setting. If you change the setting with the power on, this mode will not be switched.
b)See “When connecting the video monitor to the RGB SYNC OUTPUT connectors” on the next page.
Installation and Adjustment 75
