Connections (Continued)

When connecting the video monitor to the RGB SYNC OUTPUT connectors

Normally, set SYNC ON G in the OUTPUT SETUP menu to ON.

Set SYNC ON G to OFF in the following case: If the images displayed on the video monitor become greenish, compared with the printout, adjust the video monitor color (set the adjusted value of the video monitor color to the default). (See “Matching the Video Monitor Color to the Printer Color” on page 83.) If the images on the video monitor are still greenish, set SYNC ON G to OFF.

Making Connections to Enable Remote Control

The printer can be controlled remotely by connecting an RM-5500 Remote Control Unit (not supplied), RM-91 Remote Control Unit (not supplied), an FS-30/FS-36 Foot Switch (not supplied) or a personal computer.

Computer a)

RS-232C cable

to RS-232C

to REMOTE 1

to REMOTE 2

A

to AC IN

to

REMOTE 3

to wall outlet

AC power cord

B(supplied)

C

RM-5500 (not supplied)

FS-30 (not supplied) c)

RM-91 (not supplied) b)

a)When connecting a personal computer, select the appropriate baud rate from the SYSTEM SETUP menu. (See “Setting the Baud Rate for Computer Communication” on page 113.)

b)You can also connect an FS-36 foot switch.

c)You can also control the printer remotely by sending the signal to pin No.5 of the REMOTE 3 connector.

76Installation and Adjustment