Sun Microsystems 60 service manual 1Removing and Replacing the Power Supply Part 1

Peripheral power cable

Power supply (partially extended)

Captive screw (4)

FIGURE 8-1Removing and Replacing the Power Supply (Part 1 of 2)

8.1.2Replacing the Power Supply

Caution –Use proper ESD grounding techniques when handling components. Wear an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive components in antistatic bags before placing them on any surface.

1.Replace the power supply as follows (FIGURE 8-1and FIGURE 8-2):

a.Feed the power supply cables through the chassis opening; support the power supply cables while engaging the power supply into the chassis rails.

b.Position the power supply into the chassis.

c.Slide the power supply toward the chassis front.

d.Connect the power cables to the motherboard.

e.Connect the peripheral cable connector to the power supply.

f.Replace the peripheral power cable through the cable routing clips.

Chapter 8 Major Subassemblies 8-3