Sun Microsystems 60 Scsi Output Message, Code Example 4-22All Above Output Message

CODE EXAMPLE 4-22

CODE EXAMPLE 4-21

CODE EXAMPLE 4-21

4.7.12SCSI

The SCSI diagnostic validates both the SCSI chip and the SCSI bus subsystem. identifies the SCSI output message.

SCSI Output Message

Enter (0-12 tests, 13 -Quit, 14 -Menu) ===> 11

TEST=’selftest’

Enter (0-12 tests, 13 -Quit, 14 -Menu) ===>

4.7.13All Above

The all above diagnostic validates the system unit. identifies the all above output message.

Note –The all above diagnostic will stall if the tip line is installed on serial port A or serial port B.

CODE EXAMPLE 4-22All Above Output Message

Enter (0-12 tests, 13 -Quit, 14 -Menu) ===> 12

TEST=’all_pci/cheerio_test’

SUBTEST=’vendor_id_test’

SUBTEST=’device_id_test’

SUBTEST=’mixmode_read’

SUBTEST=’e2_class_test’

SUBTEST=’status_reg_walk1’

SUBTEST=’line_size_walk1’

SUBTEST=’latency_walk1’

SUBTEST=’line_walk1’

SUBTEST=’pin_test’

TEST=’all_dma/ebus_test’

SUBTEST=’dma_reg_test’

SUBTEST=’dma_func_test’

TEST=’ethernet_test’

SUBTEST=’my_channel_reset’

Chapter 4 Troubleshooting Procedures 4-23