Sun Microsystems 60 service manual Removing a PCI Card

1.Replace the NVRAM/TOD as follows (FIGURE 10-2):

a.Position the NVRAM/TOD and carrier on the motherboard.

b.Carefully insert the NVRAM/TOD and carrier into the socket.

Note –The carrier is keyed so the NVRAM/TOD can be installed only one way.

c. Push the NVRAM/TOD into the carrier until properly seated.

2.Replace the power supply.

See Section 8.1.2, “Replacing the Power Supply” on page 8-3.

3.Connect the AC power cord.

4.Detach the wrist strap.

5.Replace the side access cover.

See Section 7.3, “Replacing the Side Access Cover” on page 7-4.

6.Power on the system unit.

See Section 6.1, “Powering On the System Unit” on page 6-2.

10.3PCI Card

To remove and replace a PCI card, proceed as follows.

10.3.1Removing a PCI Card

1.Power off the system unit.

See Section 6.2, “Powering Off the System Unit” on page 6-3.

2.Disconnect cables from PCI card being removed.

3.Remove the side access cover.

See Section 7.1, “Removing the Side Access Cover” on page 7-2.

Caution –Use proper ESD grounding techniques when handling components. Wear an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive components in antistatic bags before placing them on any surface.

Chapter 10 Motherboard and Component Replacement 10-7