9.2.5Replacing the Diskette Drive

Note If installing a diskette drive (verses replacing), ensure that the peripheral power cable and all data cables are properly routed through the clips adjacent to the drive bay. Route the diskette drive cable through both plastic spring clips installed adjacent to the hard disk drive bay.

Caution Use proper ESD grounding techniques when handling components. Wear an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive components in antistatic bags before placing them on any surface.

1.Position the diskette drive into the RMA (FIGURE 9-3).

2.Using a number 2 Phillips-head screwdriver, replace the four screws securing the diskette drive to the RMA.

3.Replace the RMA.

See Section 9.2.6, “Replacing the RMA” on page 9-9.

9.2.6Replacing the RMA

Caution Use proper ESD grounding techniques when handling components. Wear an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive components in antistatic bags before placing them on any surface.

1.Replace the RMA as follows (FIGURE 9-2):

a.Position the RMA into the chassis, connect the rear cable connectors as required.

b.Using a number 2 Phillips-head screwdriver, tighten the captive screws securing the RMA to the chassis.

2.Replace the front bezel.

3.Connect the AC power cord.

4.Detach the wrist strap.

Chapter 9 Storage Devices 9-9

Page 147
Image 147
Sun Microsystems 60 service manual Replacing the Diskette Drive, Replacing the RMA