Sun Microsystems 60 service manual Removing the UPA Graphics Card

10.4UPA Graphics Card

To remove and replace a UPA graphics card, proceed as follows.

10.4.1Removing the UPA Graphics Card

1.Power off the system unit.

See Section 6.2, “Powering Off the System Unit” on page 6-3.

2.Disconnect the video cable from the graphics card video connector.

3.Remove the side access cover.

See Section 7.1, “Removing the Side Access Cover” on page 7-2.

Caution –Use proper ESD grounding techniques when handling components. Wear an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive components in antistatic bags before placing them on any surface.

4.Attach the wrist strap.

See Section 7.2, “Attaching the Wrist Strap” on page 7-3.

5.Remove the UPA graphics card as follows (FIGURE 10-4):

a.Using a Phillips-head screwdriver, remove the screw securing the graphics card bracket tab to the system unit chassis.

Caution –Avoid applying force to one end or one side of the board or connector damage may occur.

b.At the two upper corners of the graphics card, pull the card straight up from the slot.

c.Remove the UPA graphics card.

6.Place the UPA graphics card on an antistatic mat.

10-10Sun Ultra 60 Service Manual • August 2001