Sun Microsystems 60 service manual Probe-scsi and probe-scsi-all

CODE EXAMPLE 4-3 watch-net-allOutput Message

{0} ok watch-net-all /pci@1f,4000/network@1,1

Hme register test --- succeeded. Internal loopback test -- succeeded.

Transceiver check -- Using Onboard Transceiver - Link Up. passed

Using Onboard Transceiver - Link Up. Looking for Ethernet Packets.

‘.’ is a Good Packet. ‘X’ is a Bad Packet. Type any key to stop.

...

4.6.3probe-scsi and probe-scsi-all

probe-scsitransmits an inquiry command to internal and external SCSI devices connected to the system unit on-board SCSI interface. If the SCSI device is connected and active, the target address, unit number, device type, and manufacturer name is displayed. probe-scsi-alltransmits an inquiry command to SCSI devices connected to the system SCSI host adapters. The first identifier listed in the display is the SCSI host adapter address in the system device tree followed by the SCSI device identification data.

CODE EXAMPLE 4-4identifies the probe-scsioutput message and CODE EXAMPLE 4-5the probe-scsi-alloutput message.

CODE EXAMPLE 4-4 probe-scsiOutput Message

ok probe-scsi
Target 0
Unit 0		Disk	QUANTUM VK4550J	SUN4.2G8600
Target	6
Unit	0	Removable Read Only device		TOSHIBA

XM5701TASUN12XCD0997

CODE EXAMPLE 4-5 probe-scsi-allOutput Message

{0} ok	probe-scsi
Target	0
Unit	0	Disk	QUANTUM VK4550J SUN4.2G8600

4-10Sun Ultra 60 Service Manual • August 2001