Sun Microsystems SL500 manual LTO Configurations

LTO Configurations

LTO Configurations

The following figures show LTO storage cell and tape drive locations.

■FIGURE A-1,“Base Module LTO Cells” on page 333 shows a library with only a Base Module.

■FIGURE A-2,“LTO Cell Locations for Firmware Site Mapping” on page 334 shows a library with a Base Module that has nine reserved cells, one Drive Expansion Module, and one Cartridge Expansion Module.

■FIGURE A-3,“LTO Cell Locations for SCSI Element Numbering Mapping” on page 335 shows a library with a Base Module that has two reserved cells, one Drive Expansion Module, and one Cartridge Expansion Module. The storage cell numbering begins with the first cell after the reserved cells in column 1. The figure shows two reserved cells, but there could be more. If the reserved cells are configured as storage cells, the top cell (row 1) would be 1.

■FIGURE A-4,“LTO Cells for Back Wall of Cartridge Expansion Module” on page 336 shows the cell capacity of a Cartridge Expansion Module according to which type of module is installed above and below it.

332 SL500 User’s Guide • July 2008 Revision: KA • 96116