Inspecting Cartridges
Inspecting Cartridges
A defective or dirty cartridge can damage a tape drive. Always inspect a cartridge before you insert it into a tape drive or a library. Look for:
■
■
■
■
■
■
■
Cracked or broken cartridge Broken leader
Broken leader latch
Damaged
Labels not firmly or neatly attached or extending over the cartridge edge Any other obvious damage
Maintaining Cartridges
It is important to keep your tape cartridges in good condition. A defective or dirty cartridge can damage a tape drive see “Inspecting Cartridges” on page 348.
When you store a cartridge:
■Leave it in its protective wrapping until you are ready to use it.
■Choose a clean environment that duplicates the conditions of the room in which it is used.
■Make sure the cartridge has been in its operating environment for at least 24 hours.
When you clean a cartridge exterior:
Caution – Potential damage to cartridges. Do not use certain solvents to remove labels or to clean cartridges because they can damage the cartridges. Do not use acetone, trichloroethane, toluene, xylene, benzene, ketone, methylethyl ketone, methylene chloride, ethyldichloride, esters, ethyl acetate, or similar chemicals.
■
■
Wipe all dust, dirt, and moisture from the cartridge with a
Use StorageTek Tape Cleaner Wipes, PN
Cartridge Requirements
Cartridges must meet specifications defined in American National Standard Magnetic Tape and Cartridge for Information Interchange, ACS X3B5.
Refer to your tape drive manufacturer’s publication and Web site for specific cartridge requirements and specifications.
348 SL500 User’s Guide • July 2008 | Revision: KA • 96116 |
