Partitions and Library Resources
SCSI element numbering uses a single integer to identify each library resource. SCSI element numbering within partitioned libraries is continuous for each partition, even if cell locations for the partition are not adjacent. SCSI element addresses for a partition start at the lowest module, row, and column within the partition, then proceed by row until the end of the column, then increment by column until the end of the module.
When additional resources are allocated to an existing SCSI partition, the original resources are not renumbered. This helps to minimize disruption to the SCSI host.
SCSI Element Address Examples
If a library’s base and storage expansion modules are allocated to Partition 1 and the drive module is allocated to Partition 2, SCSI element numbering is as follows:
■Numbering for Partition 1 begins at the first available storage cell in the Base Module and continues through the last available cell in the storage module cell.
■Numbering for Partition 2 begins with the first available storage cell in the drive module PRC Address and ends with the last available cell in that module.
Storage Cells and Drives
All storage cells, tape drives, and cartridges allocated to a partition are owned exclusively by the assigned host and cannot be accessed by other hosts. For example, if a group of tape drives is allocated to a partition, only the host assigned to that partition can use those drives.
Storage cells and drives that are not allocated to any partition cannot be accessed at all. For example, you can leave an area of cells unallocated in preparation for a planned future partition.
On the SL Console screens and reports, storage cells and drives appear in any of the following states:
■
■Unallocated (or
■
■Not
Note – HandBots are shared resources and cannot be allocated exclusively to a partition.
To display partition assignments for storage cells and drives, see
150 SL500 User’s Guide • July 2008 | Revision: KA • 96116 |
