Sun Microsystems V890, V880 manual Cd /cdrom/cdrom0, Install, Eject cdrom

Maintenance

23.If you just installed an XVR-100 graphics accelerator card on a CMS R3V11 V880, continue with Installing the XVR-100 software packages (V880 and R3V11 only) on page 78.

Installing the XVR-100 software packages (V880 and R3V11 only)

The XVR-100 software packages must be installed after you install a new XVR-100 graphics accelerator card. If you are replacing an existing XVR-100 graphics accelerator card, you do not have to reinstall this software.

To install the XVR-100 software packages on a Sun Fire V880 system:

1.Verify that your CMS system is running CMS R3V11 by entering: pkginfo -x cms

Note:

Do not perform this procedure if your CMS system is running a later load of CMS. The software packages were installed with the Solaris operating system.

2. Verify that the XVR-100 graphics accelerator card is installed.

Note:

For information on how to install the XVR-100 graphics accelerator card, see the Sun documentation that was shipped with the card.

3.Load the Sun XVR-100 FCS software disk into the disk drive.

4.Enter:

cd /cdrom/cdrom0

5.Enter:

./install

The system installs the SUNWpfbx.u, SUNWpfbcf, SUNWpfbw, and SUNWpfbmn packages.

6.Enter:

/usr/sbin/shutdown -y -i0 -g0

The system shuts down and displays the ok prompt.

7.Enter: boot -r

8.Log into the system as root.

The system reboots and displays the # prompt.

9.Enter:

eject cdrom

78 Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006