Sun Microsystems V880, V890 manual Setenv auto-boot? true Boot

Turning on the system and verifying POST

11.Enter: probe-ide

This verifies that the system sees the DVD drive (IDE model in V890). A message that is similar to the following example is displayed:

Device 0 ( Primary Master )

Removeable ATAPI Model: TOSHIBA DVD-ROM SD-M1712

Device 1 ( Primary Slave )

Not Present

12.Verify that the DVD is recognized. If it is not recognized, see Troubleshooting disk drives and DVD drives on page 186 for more information.

13.When you have verified that the system recognizes all its devices, enter the following commands:

!CAUTION:

If you fail to reset the auto-boot option, any reboots that you do in the future will stop at the boot prompt instead of proceeding through the normal boot-up process.

setenv auto-boot? true

boot

The system reboots.

14.Turn the key switch to the Locked position. Keeping the switch in the Locked position prevents anyone from accidentally turning off the system. See the following figure.

Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006 43