Sun Microsystems V890, V880 manual Sunw Sunwgs INT FCBPL9224

Installation

6. Press and release the power button to the left of the key switch to turn on the system.

Note:

The POST diagnostics occur each time that you turn on the system. The POST diagnostics test the basic system components and can take several minutes.

While the system turns on, the power LED on the monitor flashes.

7.Press Stop+A simultaneously as soon as the monitor power LED lights steadily and the Sun logo is displayed on the monitor.

The ok prompt is displayed.

8.Enter the following commands: setenv auto-boot? false reset-all

The system resets to the ok prompt.

9.Enter: probe-scsi-all

This command verifies that the system sees the disk drives and backplane, the tape drive, and the DVD drive (SCSI model in V880). A message that is similar to the following example is displayed:

/pci@8,600000/SUNW,qlc@2				-----Disk description -----
LiD HA LUN			--- Port WWN ---
0	0	0	21000004cf72f08f	SEAGATE ST373405FSUN3660438
1	1	0	21000004cf721553	SEAGATE ST373405FSUN3660438
6	6	0	508002000016b5b1	SUNW	SUNWGS INT FCBPL9224
3	3	0	21000004cf72114b	SEAGATE	ST373405FSUN3660438
4	4	0	21000004cf7211ae	SEAGATE	ST373405FSUN3660438

/pci@8,700000/scsi@1
Target 5		Removeable Tape	HP	C7438A	V309
Unit 0
Target	6	Removeable Read Only device TOSHIBA DVD-ROM SD-M14011009
Unit	0

/pci@8,700000/pci@5/SUNW,1sptwo@4

10.Verify that all the devices are recognized. If the devices are not recognized, see Troubleshooting disk drives and DVD drives on page 186 for more information.

42 Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006