Part ISounds and effects

REVERB

SOLO

REVERB applies a reverberation effect to the sound. This

Each part can be set to monophonic sound.

effect is applied to all the parts in common.

 

Press the REVERB button to turn it on.

REVERB

This effect does not work for the METRONOME.

Type and parameter settings

1.Press and hold the REVERB button for a few

seconds.

The display changes to the following.

1.Select a part.

2.Press the SOLO button to turn it on.

SOLO

The sound of that part will be monophonic.

This feature does not work for the DRUM KITS sounds.

When two CONDUCTOR parts, one with the SOLO turned on and one with the SOLO turned off, are mixed, then only the highest pitch of the played chord plays in the sound for which the SOLO is turned on.

In the initialized condition, the SOLO is automatically turned on or off depending on the sound you select.

BRILLIANCE

The brightness of the sound can be set for each performance part.

2.Use the and buttons to select an effect

group.

The EFFECT MEMORY is for edited effects (see below).

3.Use the buttons to the right of the display to

select the type.

If the types comprise more than one display “page,” use the PAGE buttons to switch pages.

4.Use the TOTAL DEPTH and buttons to set the depth of the effect.

This display can also be accessed from the REVERB & EFFECT display. (Refer to page 109.)

EFFECT EDIT

Your edited effect can be stored in a memory for later recall.

The procedure is the same as for MULTI EFFECT.

1.Press the BRILLIANCE button.

BRILLIANCE

The display looks similar to the following.

2.Use the PART and buttons to select a part.

3.Use the buttons to the left of the display to select the level of brightness.

For some sounds, the brightness does not change.

The display returns to the previous display a few seconds after you have changed the setting.

Sounds and effects

Mic Reverb & Effect

These settings apply when a microphone is connected to the MIC input terminal and, for example, you wish to add a reverb effect the to microphone input.

1. Press the PROGRAM MENUS button to turn

2. Select REVERB & EFFECT.

it on.

 

PROGRAM

3. Select MIC REVERB & EFFECT.

MENUS

The display looks similar to the following.

 

The display looks similar to the following.

(continued on the next page)

41

QQTG0665

Page 41
Image 41
Technics sx-PR804/M, sx-PR604/M operating instructions Mic Reverb & Effect, Reverb Solo, Brilliance