Technics sx-PR804/M On the Sound Menu display, select Mixer, Adjust each parameter 1/5 2/5

Part VII Sound

<PAGE 4>

MONO/POLY MODE:

Use the MONO/POLY MODE∧ and ∨ buttons to select the output mode.

PORTAMENTO:

Use the ON/OFF buttons to enable or disable the porta- mento function. (Portamento is a continuous gliding move- ment from one tone to another.)

•Use the ∧ and ∨ buttons to specify the portamento time.

•PORTAMENTO does not function for the POLY MODE.

BEND RANGE:

Use the BEND RANGE ∧ and ∨ buttons to specify the PITCH BEND range (0 to 12). Increments are in semi- tones.

The higher the number, the greater the change in pitch when PITCH BEND data is received as MIDI data.

MODULATION SENSITIVITY:

Use the MOD. SENS ∧ and ∨ buttons to adjust the sen- sitivity of the MODULATION (when MIDI data is recieved).

•Use the MSB ∧ and ∨ buttons (half-tone increments) and the LSB ∧ and ∨ buttons to adjust the setting.

Mixer

Use the MIXER display to visually adjust the major settings of each part. Use this display to make broad, general changes to the settings.

1.On the SOUND MENU display, select MIXER.

•The MIXER display consists of 5 pages. Use the PAGE buttons to switch among the pages.

•Each time the OTHER PARTS/TR button is pressed, the part that is displayed changes.

2.Adjust each parameter.

<PAGE 1/5> <PAGE 2/5>

Sound

SOUND:

Select SOUND. Use the buttons below the display to set the sound for the corresponding part.

•The buttons in the panel can also be used to select the sound.

PAN:

Select PAN. Use the buttons below the display to adjust the stereo balance of the corresponding part (L64–CTR– R63).

VOLUME:

Select VOLUME. Use the buttons below the display to adjust the volume of the corresponding part (0 to 127).

•To mute a part, press both the corresponding balance buttons as the same time. To cancel the mute, press either balance button for the part.

REVERB:

Select REVERB. Use the buttons below the display to set the level of the REVERB for the corresponding part (0 to 127).

MULTI:

Select MULTI. Use the buttons below the display to set the MULTI EFFECT to ON or OFF for each part.

MULTI DEPTH:

Select MULTI DEPTH. Use the buttons below the display to adjust the depth of the MULTI EFFECT for the corre- sponding part (0 to 127).

105

QQTG0665