Technics sx-PR604/M, sx-PR804/M operating instructions Drive, Disk, Other

	Phenomenon	Remedy
	Storage is not possible.	• The remaining memory capacity of the COMPOSER is 0.
	Setting the time signature and number of measures is	• The time signature and number of measures cannot be changed
COMPOSER	not possible.	for a pattern which is currently recorded in the COMPOSER. If
		you wish to change the time signature and/or measure data,
		first follow the procedure to clear the memory. (Refer to page
		86.)
	The playback timing of the rhythm pattern is different	• The QUANTIZE function was on when the pattern was recorded
	from the timing with which it was recorded.	and the timing was automatically corrected. Set the quantize
		level to a smaller note unit or to OFF when recording. (Refer
		to page 88.)
	The Disk Drive produces a noise during recording or	• This occurs when the Disk Drive is reading a disk. It does not
	playback.	indicate a problem.
Drive
	When the procedure to load from a disk is performed,	• When performing the load operation from a disk, this
	the contents of the keyboard memory are erased.	instrument’s memory changes to that of the data loaded from
Disk		the disk. If you wish to preserve a song which is stored in this
		instrument’s memory, save it on a disk before performing the
		load procedure. (Refer to page 99.)
	Data cannot be exchanged through MIDI terminals.	• Match the channels on the transmitting side and the receiving
		side. (Refer to page 127.)
	The sound quavers or is distorted.	• When the USB terminal or both the MIDI IN and OUT terminals
		are connected to a computer, depending on the computer
		software the received data may be sent back to the instrument
MIDI		just as it is. Because of this the sound generated from the keys
		and the sound generated from the returned data are both
		produced, causing undesirable effects, such as the sounds
		canceling each other out, for example. In this case, either
		change the software settings to prevent received data from
		being returned, or set the MIDI LOCAL CONTROL to off.
	Noise from a radio or TV can be heard.	• This sometimes occurs when electrical equipment such as a
		radio or TV is used near the instrument. Try moving such
		electrical equipment further away from the instrument.
Other		• The sound may be coming from a nearby broadcast station or
		amateur radio station. If the sound is bothersome, consult your
		dealer or service center.
	The cabinet becomes warm during use.	• This instrument has a built-in power source that heats the
		cabinet to some degree. This is not an indication of trouble.

140

QQTG0665