Part IX

Sound Edit

<Equalizer>

For LPF(6)+EQ/HPF(6)+EQ filters, the sound quality can be modified by the EQUALIZER.

RANGE

Select the setting range (HIGH or LOW).

FREQ

Set the standard frequency.

GAIN

Set the level increase or decrease from the value set for

FREQ (dB).

6.Repeat steps 2 to 5 for each tone, as desired.

TOUCH & KEY FOLLOW

Adjust how the filter is applied relative to touch and pitch.

1.Use the PAGE buttons to view the 2/4 display.

The display looks similar to the following.

2.Use the buttons to the left of the display to select a tone.

3.Use the FILTER TOUCH and buttons to modify how the respective filters are applied

relative to key touch.

Use the CUT OFF and buttons to specify the amount of change in the cut-off frequency. Use the CURVE and buttons to specify the curve of change. Use the RESO and buttons to specify the degree of change in the resonance value.

4.Use the FILTER KEY FOLLOW and but- tons to modify how the respective filters are

applied relative to note pitch.

Use the SLOPE and buttons to adjust the bend slope. Use the RANGE and buttons to specify the pitch range.

5.Repeat steps 2 to 4 for the other tones, as desired.

FILTER ENVELOPE

Specify how the filter changes over time, from the time the key is played to the time the sound dies out.

1.Use the PAGE buttons view the 3/4 display.

The display looks similar to the following.

2.Use the buttons to the left of the display to select a tone.

3.Use the FILTER ENVELOPE and buttons

to modify the respective filter envelopes.

Use the buttons below the display to adjust the respective settings.

You can use the CUTOFF ADJUST buttons to set the total upper and lower settings, the START POINT buttons to set the start point, and the STOP POINT buttons to set the stop point.

4.Repeat steps 2 and 3 for the other tones, as desired.

Sound Edit

115

QQTG0665

Page 115
Image 115
Technics sx-PR804/M, sx-PR604/M operating instructions Touch & KEY Follow, Filter Envelope, Equalizer