Technics sx-PR604/M, sx-PR804/M operating instructions Common Setting

Part XII MIDI

MIDI

Common Setting

Set the functions which are common to all parts.

1.On the MIDI MENU display, select COMMON

SETTING.

•The display looks similar to the following.

2.Use ▲ and ▼ buttons to select the item.

NOTE ONLY:

Of the performance data, specify whether or not only note data is exchanged.

PROGRAM CHANGE TO P. MEM:

Enable or disable the exchange of program change num- bers for the RIGHT 1 part by operation of the PANEL MEMORY buttons.

•For this setting, the PANEL MEMORY 1 to 8 program change numbers correspond to the bank numbers as follows:

BANK A = 0 to 7 BANK B = 8 to 15 ...

DRUMS TYPE NX SOUND:

Keyboard percussion instrument sounds correspond to the same key note numbers for connected NX SOUND Technics models that are set to this type.

PREV. TECH:

Keyboard percussion instrument sounds correspond to the same key note numbers for connected non- NX SOUND Technics models that are set to this type.

SONG SELECT

ON: Song number data can be exchanged.

OFF: Song number data cannot be exchanged.

PREVIOUS MODEL MODE

ON: INTRO, FILL IN, ENDING and APC CONTROL, FADE IN/OUT data are converted to CONTROL CHANGE data for previous models* and then trans- mitted.

OFF: The above settings are not converted.

*“Previous models” include all Technics instrument mod- els except for:

KN7000/6500/6000

PR604/804/603/703/903/1000

3.Use ∧ and ∨ buttons to change the setting.

INTRO, FILL-IN, ENDING:

Enable or disable the exchange of intro, fill-in and ending data.

APC CONTROL:

Enable the exchange of data for the on/off status of the AUTO PLAY CHORD modes.

FADE IN/OUT:

Specify whether or not FADE IN/OUT data is exchanged.

PROGRAM CHANGE MODE

NX SOUND:

Program change numbers are standardized among NX SOUND Technics models which are set to this mode. The program change number assigned to a given sound on one model is assigned to the same sound on all models which are set to the same mode.

PREV. TECH:

Program change numbers are standardized among non-NX SOUND Technics models which are set to this mode. The program change number assigned to a given sound on one model is assigned to the same sound on all models which are set to the same mode.

MAP R:

GS basic sounds are transmitted and received as GS program change numbers.

MAP Y:

XG basic sounds are transmitted and received as XG program change numbers.

*GS is a trademark of Roland Corporation. XG is a trademark of Yamaha Corporation.

4.Repeat steps 2 and 3 for the other settings as desired.

130

QQTG0665