Technics sx-PR804/M, sx-PR604/M Sequencer Play, Cycle Record, Start END Cycle END Measure

Part IV Sequencer

CYCLE RECORD

This mode allows you to have specified recording measures continuously repeated. Thus you can record measures by adding notes during any cycle.

1.On the REALTIME RECORD display, specify “REC” for a track number you are going to record, and “PLAY” for track numbers you wish to have played back.

2.Press the CYCLE: OFF button.

•The display looks similar to the following.

3.Use the START MEASURE ∧ and ∨ buttons to specify the beginning measure number.

4.Use the END MEASURE ∧ and ∨ buttons to

specify the ending measure number.

•The measure in which the END command has been stored can also be specified.

5.Press the START/STOP button.

•If the metronome is on, cycle recording of the specified measures begins after a two-measure count.

•Recording does not start even when the keyboard is played.

6.Play the keyboard.

•The specified measures are repeated, during which time you can record by adding notes little by little at the correct timing (over-dubbing).

•If you wish to erase all the performance data from the specified measures, press the CLEAR button.

•If the CYCLE: ON button is pressed, it changes to OFF. This button does not function during recording.

•To return to the REALTIME RECORD display, press the EXIT button.

•Cycle record can also be started from the REALTIME RECORD display whenever the CYCLE: ON indication is shown.

7.When you have finished recording, press the REC STOP button on the display, or turn off the PROGRAM MENUS button.

START			END
1	2	3	4

CYCLE END MEASURE: 4

Sequencer Play

Play back your recorded performance.

1.Press the SEQUENCER PLAY button to turn it on.

SEQUENCER

PLAY EASY REC

CHORD STEP REC

•The display looks similar to the following.

2.Use the SONG button to select the song num- ber you wish to play back.

3.Use the balance buttons below the display to show “PLAY” above the track numbers you

wish to have played back.

•Highlighted track numbers indicate tracks that are already recorded. Only highlighted track numbers can be selected for playback.

•You can select two or more tracks to play back at one time.

4.Press the SEQUENCER RESET (FILL IN 1)

button.

•The SEQUENCER returns to the beginning of the song and the beginning panel settings are recalled.

5.To begin playback from a measure other than

measure 1, press the MEAS button, and then use the MEAS ∧ and ∨ buttons to specify the

beginning measure.

•“MEASURE=” indicates the current measure number.

6.Press the START/STOP button.

•The recorded performance is played back from the specified measure.

•When playback is begun from a measure in which an INTRO, COUNT INTRO, FILL IN or ENDING is recorded, the corresponding function does not work.

•You can press the MIXER button and modify the settings for each part.

7.To stop playback, press the START/STOP but-

ton.

•If the START/STOP button is pressed again, playback will continue from the point it was interrupted.

Sequencer

67

QQTG0665