Part IV

 

Sequencer

 

Correct the recorded rhythm progression

 

TRACK CLEAR

 

 

 

 

1.Follow the procedure to select the STEP RE- CORD: RHYTHM display.

2.Use the MEAS buttons to go to the measure you wish to modify. (The * is highlighted.)

3.Correct the rhythm data.

Press the ERS button to erase data at the cursor position.

If you wish to cancel the REPEAT, enter an END com- mand.

If you select a rhythm with a different time signature, the time signature of all subsequent measures will also change.

If data has already been recorded in other tracks, you cannot select a rhythm with a different time signature.

To erase all data from the current track, press the CLR button, and then press the YES button on the confirmation display.

If you wish to cancel the clear procedure, press the NO button.

Track Assign

Each SEQUENCER part is already assigned to a track number. However, you can use the TRACK ASSIGN function to assign parts to tracks as you wish.

Sequencer

1.On the SEQ MENU display, use the SONG and buttons to select the song number. Then select RECORD & EDIT.

2.On the RECORD & EDIT display, select

TRACK ASSIGN.

The display looks similar to the following.

3.Use the TR and buttons to select the track.

4.Use the TRACK ASSIGN and buttons to

select the part for the specified track.

When a part other than the CONTROL, APC, CHORD or RHYTHM part is assigned, the track assign procedure is completed at this point.

Either the CHORD part or APC part can be assigned to a track, but not both.

The CONTROL, APC, CHORD and RHYTHM parts cannot be assigned to more than one track.

You can use the ON and OFF buttons for LOCAL CONT. to specify whether or not the sound of the part assigned to this track is generated. Because no sound is generated for this instrument’s parts assigned to tracks set to OFF through this procedure, use this setting to generate sound from an external sound source through the MIDI connec- tors.

You can use the MIDI OUT ON and OFF buttons to specify whether or not the data of the part assigned to this track is sent as MIDI data. When set to OFF, the data is not sent, even if MIDI equipment is connected.

TRACK ASSIGN PRESET

A preset track assignment can be selected.

1.On the TRACK ASSIGN display, press the

PRESET button.

The display looks similar to the following.

2.Use the SONG and buttons to select the song number for which the preset track as-

signment will be effective.

If ALL SONGS is selected, the track assignment is effec- tive for all the songs.

3.Select the track assign mode.

INITIAL:

Factory-preset settings.

TECHNICS MULTI RECORDING:

The optimum track assignment for multiplex recording.

GM MULTI RECORDING:

The optimum track assignment for creating GENERAL MIDI data.

4.Press the OK button.

“COMPLETED!” is shown on the display and the selected track assign mode is enabled.

You can confirm the track assignment settings on the TRACK ASSIGN display.

5.When assigning the CONTROL, APC, CHORD or RHYTHM part, press the OK button.

76

QQTG0665

Page 76
Image 76
Technics sx-PR604/M, sx-PR804/M operating instructions Correct the recorded rhythm progression, Track Assign Preset